Bigben BB 8076 Manual Del Usuario página 7

Programming:
1. Press the PRG (PROGRAM) button and hold it down for 1 second. The Red and Green LEDs will come on.
2. Press and hold the control you want to reprogram. (e.g. right pedal) You must keep this control pressed
while you complete the next step. The Red and Green LEDs will flash.
3. Press and release the button that should be sent to the console. (e.g X button)
The Red and Green LEDs will flash rapidly. You can now release the control pressed in step 2.
The Red and Green LEDs will now turn on continuously.
You have now successfully programmed your buttons (the right pedal button now acts as the X button).
4. Repeat steps 2) and 3) to programme other buttons.
5. Press the PRG (PROGRAM) to exit programming mode.
The LED indication will return to the condition before programming. (This could be Red continuous,
Green continuous or Red flashing if the steering angle has been programmed.)
To delete all programmed changes, press and hold down the START and PRG (PROGRAM) buttons at the
same time. The Red and Green LEDs will flash 3 times.
The LED indication will then return to its original condition.
(If you continue to hold the START and PRG buttons the flashing LED indication will repeat.)
All programming will then be reset to default.
NB: The START and SELECT action buttons cannot be reprogrammed.
The two separate pedal modes enable you to quickly and easily configure the pedals to be compatible
with your driving games.
If you are unsure which controls your driving game uses, try the GT mode first and then try the NFS
mode.
RIGHT Pedal
LEFT Pedal
Note : This racing wheel deluxe is upgradable. If you ever experience any compatibility issues, especially
after a firmware update to your console, simply download the update program from our website,
install the program on your PC and follow the onscreen instructions.
Download from: http://www.bigben-interactive.co.uk/support
Assistance and technical support
The racing wheel deluxe is not responding.
1. Check that the cable is correctly connected to your console / PC.
2. Check that your chosen game is compatible with the mode you are trying to use.
If necessary, switch off the system and disconnect all the cables.
3. Reconnect the cables and switch the system on again.
4. If it is not working on a PS3™, ensure it is set as controller one as noted in the section 'Using your
wheel' .
The pedal set is not responding.
1. Check that the cable between the pedal set and the racing wheel deluxe is properly connected.
2. Check that the buttons assigned to the pedals are the same as those used in your game. Use the pedal
selection switch to change between GT mode and NFS mode.
GT Mode
X (Cross)
(Square)
7
NFS Mode
R2
L2