X-lander X-RUN Manual Del Usuario página 9

1 U N F O L D I N G T H E S T R O L L E R
Detach fastening tape. Unfold the stroller rising the handle up till locks' latching and
blockage the handle.
2 F O L D I N G T H E S T R O L L E R
Fold the hood. Unblock the locks by pulling up the holders. When pulling, turn the hold­
ers in the indicated direction. Fold the stroller and the handle pushing on the buttons
on the handle adjuster and fasten the stroller with the safety webbing. Attention: Fold or
remove the guardrail before folding the trolley.
3 F R O N T W H E E L' S A S S E M B LY A N D D I S A S S E M B LY
To disassembly front wheel, pull assembling lock's lever away and remove the wheel.
Remember to block the wheel by pressing lock's lever during assembly. Strength of pres­
sure should be regulated by nut, which is placed on opposite side of the wheel's axel.
4 A S S E M B LY A N D D I S A S S E M B LY O F R E A R W H E E L S
To assembly or disassembly the wheel, push rubber button, which is in the middle of the wheel.
5
A S S E M B L I N G A N D R E M OV I N G T H E H O O D
To mount the hood, slide the end plastic elements through the fence (a) and fasten
the snaps on the sides and the back of the backrest.To remove the hood, unfasten the
snaps, press the locking element and slide from the fence.
6
I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
7 B R A K E
To block the wheels, push brake's lever on both wheels. To unblock the wheels, release
brake's lever.
8 B AC K R E S T R E G U L AT I O N
To lower the backrest squeeze the lock levers and push the backrest downwards (a).
To lift the backrest pull the strap end as shown in the picture.
9
P U S H B A R
Press both buttons on the handle of the push bar to adjust the height.
10 B E LT A D J U S T M E N T
To adjust the belt length, move the belt towards a regulator. Regulators are hidden under
protective covers.
11
S H O U L D E R B E LT A D J U S T M E N T
The height of the shoulder belt position may be adjusted based on the child's height.
To change the position, insert the regulator through appropriate holes located in the
reclining seat.
12
B U C K L E
To fasten the belt buckle, slide the belt lock into the slot and press it down until it snaps
into place (a). Repeat this procedure for all locks. To unfasten, press the round button
until the moment when the locks are released from the buckle latch (b).
13 G UA R D R A I L A DA P T E R S A S S E M B LY
To assemble the guardrail adapters, pull out the red lock lever and remove the plugs
from the mounting slots (a). Then, slide the guardrail adapters into the mounting slots
until the locks engage (b).
7