Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and cleaning
Before cleaning the appliance, be sure to switch the unit off and unplug it from the power supply.
In some areas the water tends to be hard, with high levels of calcium and magnesium ions, while in other areas water purifying agents are
used such as calcium chloride. Consequently, when using the humidifier some calcium and magnesium ions may be sprayed together
with the water vapour and will be dispersed over surfaces, forming a type of "white dust". Some ions will be deposited on the surface of
the transducer and the water tray and will form scale due to the impurity of the water. This scaling will affect the correct operation of the
humidifier. It is therefore recommended that you use distilled water.
1.
To clean the water tank (once every two weeks): remove the cover from the water tank, clean the inside with a soft cloth and scrub
it with pure water.
2.
To clean the water tray (once a week): clean the tray with a soft cloth or brush and then scrub it with pure water.
3.
Renew the water in the tank frequently to keep it clean.
4.
Do not leave water in the tank or in the water tray when the humidifier is not in use for a long period.
5.
Clean and dry all the parts of the humidifier and then put them in the original packaging to store them.
Should the humidifier not function correctly, examine the appliance before taking it to an authorised service agent.
Description of the Fault
The power light is off and the
appliance is not giving out
any air or water vapour.
The power light is on and the
appliance is giving out air but
not water vapour.
The water vapour has a
strange smell.
The power light is on and the
appliance is not giving out
any air or water vapour.
Lack of power.
Abnormal noises.
Steam escaping around the
nozzle.
The water in the tank is
not circulating through the
appliance.
Thank you for putting your trust in one of our products.
Analysis of the causes
The power supply is disconnected.
The main switch is off.
There is no water in the tank.
The cover of the water level protection
switch is not closed properly.
Using the appliance for the first time.
The water is dirty or has been stored
for too long.
The water level in the tray is too high.
Scaling on the transducer.
The water is dirty or has been stored
for too long.
Reverberations caused by too low a
level of water in the tank.
Reverberations caused by the surface
on which the appliance is situated.
There are gaps between the nozzle
and the water tank.
The hole in the water tank cover is
blocked.
How to correct the fault
Connect the power supply and switch it on.
Switch the switch on.
Add water to the tank.
Put the cover on again.
Stand the water tank uncovered in the fresh air for
12 hours.
Clean the tank and replace the water.
Remove some water from the tray and close the
cover.
Clean the transducer.
Replace the dirty water with clean water.
Add water to the tank.
Put the appliance on a flat surface or on the floor.
Soak the nozzle in water before using it.
Clean the blocked hole.
9
Publicidad
