Black+Decker HLWVA325J Manual De Instrucciones página 6

Aspiradora de mano inalámbrica para húmedo/seco
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
For best performance on hard surface wet pickups, insert
squeegee into the bowl nozzle opening.
For best results when using this accessory, hold the
appliance at an angle of 45° and pull it slowly towards you.
Do not fill the bowl beyond the end of the intake chute.
If there is any liquid in the bowl, do not turn the unit
upside down, sideways, point the nozzle upward, or
shake the vac excessively.
After picking up liquid substances clean the vac and
filter immediately. Mold and mildew may form if the
unit is not properly cleaned after wet pickups.
If charging in a vertical position, be sure to empty all
liquid contents to avoid damage to your appliance.
Switching on and off (Fig. G)
Figure F - To start, slide the On/Off switch
(i.e. "O"= Off, "I" = On).
To stop, slide the switch back.
Return the product to the charger immediately after use
so that it will be ready and fully charged for the next
use. Ensure that the product is fully engaged with the
charger plug.
Fig. G
Cleaning and emptying the product
(Fig. H - K)

WARNING:
Never use the vac without its filter.
nOTE: The filter is re-usable, do not confuse it with a
disposable dust bag, and do not throw it away when the
product is emptied. We recommend that you replace the
filter every 6–9 months depending on frequency of use.
There are two methods of cleaning the bowl, a quick empty
method and a thorough clean method.
Figure h - Press the dust bowl release button
handle and remove the dust bowl.
4
forward
1
1
Projectile/Respiratory Hazard:
2
on the
Fig. H
Remove the deflector
Figure i -Remove foam filter
deflector
6
.
Fig. I
Figure J - Empty the debris from the bowl
Shake or lightly brush any loose dust off the deflector
and filter.
Fig. J
Figure K -The dust bowl, deflector and foam filter can
be washed in warm soapy water. Allow to dry before
placing back into the vac.
Fig. K
Place dry foam filter back into deflector and then place
deflector assembly into the dust bowl, pressing firmly to
ensure a secure fit.
from within the bowl.
6
7
from within the
6
7
4
.
4
4

Publicidad

Tabla de contenido
loading

Tabla de contenido