Página 1
1 Trailhawk Front Mask www.mopar.com Call Out Description Quantity Ziffer Beschreibung Anzahl Front Mask Frontmaske Hood Mask Motorhaubenmaske Spoiler Board Spoilerbrett ...
Página 2
• Hand clean mask using mild soap, rinse thoroughly with clean water, and line dry completely. Do not machine dry! • Use Mopar® Vinyl Protector (P/N 4318017) to preserve color and finish. • For best results, install cover in a surrounding environment of at least 65° F. This will allow the cover to stretch and ease installation.
Página 3
à la machine. • On peut utiliser le protecteur, Mopar® Vinyl Protector (P/N 4318017), pour garder la couleur et le fini. • Pour de meilleurs résultats, installer le protecteur à une température ambiante de plus de 65 degrés. Il s'étirera plus facilement et cela en facilitera l'installation.
Página 4
4 www.mopar.com 6 K6862780 November 13, 2016...
Página 5
5 www.mopar.com Note: If State or Province law requires use of a front license plate, cut inside edge of 4 embossed squares at center of front mask. Discard square vinyl pieces. Do not cut out sections while mask is installed on vehicle.
Página 6
6 www.mopar.com K6862780 November 13, 2016...
Página 7
7 www.mopar.com w Note: If State or Province law requires use of a front license plate, install bracket and plate on front of vehicle. Hinweis: Wenn die Verwendung eines vorderen Kennzeichens gesetzlich vorgeschrieben ist, muss das Kennzeichen mit der Halterung an der Vorderseite des Fahrzeugs angebracht werden.
Página 8
WARNING IF THIS COVER BECOMES DAMP OR WET, IT MUST BE REMOVED AND ALLOWED TO DRY BEFORE REINSTALLATION. FAILING TO REMOVE A WET COVER AND ALLOWING IT TO DRY IN PLACE ON THE VEHICLE COULD RESULT IN PAINT DAMAGE. SHOULD PAINT DAMAGE (i.e. FOGGING) OCCUR, REFER YOUR DEALER TO TECHNICAL SERVICE BULLETIN #23-25-00.