Warning Symbols - Black and Decker CS355 Manual De Instrucciones

ENGLISH
Regularly clear the ventilation slots when working in dusty
u
conditions. If it should become necessary to clean the
slots, remember to unplug the tool first.
Always store cutting discs well-protected and in a dry
u
place, out of reach of children.
Warning!Use of this tool can generate dust containing
u
chemicals known to cause cancer, birth defects or other
reproductive harm. Use appropriate respiratory protection.
Warning! Only use a chop saw wheel with a
maximum thickness of 3 mm and a maximum
diameter of 355mm.
Warning! The cutting wheel will continue to rotate after the
tool has been switched off.
Use only reinforced wheels rated 4300 rpm or higher.
u
Always wear eye protection, use guards, clamp work in
u
vise, use proper respiratory protection.
The following factors are of influence to noise production:
the material to be cut
u
the type of the cutting disc
u
the feed force
u
Warning!Take appropriate measures for the protection of
u
hearing.
Residual risks
The following risks are inherent to the use of these
machines:
injuries caused by touching the rotating parts
u
injuries caused by disruption of the cutting disc
u
These risks are most evident:
within the range of operation
u
within the range of the rotating machine parts
u
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These are:
Impairment of hearing.
u
Risk of accidents caused by the uncovered parts of the
u
rotating cutting disc.
Risk of injury when changing the disc.
u
Risk of squeezing fingers when opening the guards.
u
Electrical safety
#
Your tool is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit
with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
6
(Original instructions)
Voltage drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than 0.12 Ω, disturbances are unlikely to occur.

Warning Symbols

The following symbols are found on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
O
Always wear safety goggles.
N
Always wear safety hearing protection.
Features
This tool includes some or all of the following features.
A. Lock Chain
B. Spark deflector screw
C. Spark deflector
D. Base
E. Fence
F. Vice
G. Flat Wrench
H. Crank
I. Vice Lever
J. Cutting disc
K. Guard
L. Spindle Lock
M. Depth Stop Bolt and Locking Nut
N. Trigger Switch
O. Padlock Hole
P. Fence Bolts
Assembly
Warning! Turn off and unplug the tool before making any
adjustments or removing or installing attachments or
accessories. Be sure the trigger switch is in the OFF position.
Do not make any adjustment while the wheel is in motion..
Removing and fitting a cutting disc (fig. 7 - fig 8)
Push in the spindle lock (L).
u
Rotate the cutting disc (J) until it locks.
u
Using the flat wrench (G), remove the bolt (S) by turning
u
counterclockwise and then remove the washer (T) and the
retaining flange (U).
Check that the spacer (R) is in place against the flange.
u