Profi Care PC-HR 3012 Manual De Instrucciones página 27

NOTE: Mains Operation
Is the battery completely empty and do you want to operate
the appliance with the cord? Charge the battery for a few
seconds. After that, you may operate the appliance with
the cord.
CAUTION:
After 2,5 hours always disconnect from mains power supply.
NOTE: Lifetime of Rechargeable Battery
You can extent the lifetime of the rechargeable battery by
following these steps:
• Only charge after the battery is nearly exhausted.
• Do not charge for more than 2,5 hours.
• Charge the appliance at temperatures between 0 °C
and + 40 °C.
WARNING:
• Before cleaning the handset with water, disconnect it from the
connection cable.
• Disconnect the power adapter from the wall socket when cleaning.
• Do not immerse the appliance and the power adapter into water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
Shaving Head
CAUTION:
The shaving foil must not be cleaned with the brush.
Use the brush to clean the cutter block and the inside of the
shaving head.
You may clean the shaving head under running water.
1. Switch off the appliance.
2. Press the shaving head buttons.
3. Rinse the shaving head and the cutter block under hot
running water. Clean the shaving head in soapy water
once in a while.
PC-HR3012_IM
1. Remove the protective cover.
2. Push the switch upwards. " " is visible.
3. Hold the shaver at a right angle to your face.
4. Follow the outline of your face, and continue to hold the
shaver at a right angle to your skin. Small irregularities will
be corrected by the flexible shaving head.
NOTE:
• Shave against the direction of hair growth.
• If necessary, stretch the skin with your free hand.
Using the Long Hair Cutter
With the long hair cutter, you can trim head hair or beard hair
in a controlled manner.
• Use the slider to turn the long hair cutter off or on.
Stop Operation
Stop operation by pushing the switch downwards. " " is
visible.
Cleaning
CAUTION: Cutter Block
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
Cleaning the Hand-held Unit and Power Adapter
• You may wipe these parts with a damp cloth.
• Use slightly soapy water to remove spots.
Maintenance and Replacement
• Clean the cutter block thoroughly once a month. If nec-
essary, use special cleaning aids available in specialist
shops.
• Lubricate the shaving foils and the long hair cutter using
light machine oil (a few drops are enough).
Shaving
Remove the cutter block as a whole
only. Otherwise, the smaller parts
may become lost. To remove the
cutter block, withdraw it from the
appliance using the white connect-
ing piece.
18.10.17
27