Thank you for purchasing the Jumpstart 12"
Lighting System. The highly reflective material
directs light downward, bathing your plants in
full-spectrum light and increasing your growing
success with starts, cuttings, herbs, flowers, or
vegetables.
WHAT'S IN THE BOX
1 - 12" lighting fixture with reflector and T5 HO
bulb
4 - Extension wireform legs
2 - Lamp socket caps
2 - Stand clips (each with two pre-assembled
plastic screws)
WARNINGS
• Do not attempt to replace or repair a
damaged power cord.
• To avoid electrical shock, do not expose the
fixture or its components to water or liquid.
• Keep fixture unplugged when not in use.
• Do not operate the fixture in the presence of
explosive or flammable vapors.
• Do not place the fixture near an open flame,
cooking, or heating appliances.
• Do not pull the power cord to disconnect it
from the power source. Grip the plug base.
• This system is designed to be operated
indoors only.
• Do not operate the fixture with a damaged
cord or plug. Discard fixture or return to an
authorized service facility for examination
and/or repair.
• Do not run the cord under carpeting or
similar coverings.
• Do not run the cord under furniture or
appliances.
ASSEMBLY & MOUNTING FOR
OXYCLONE 20 SITE SYSTEM
1. Assemble the plastic cap on the strip.
Assemble the other cap in the same way.
Please disregard this step if the plastic caps
are pre-assembled (see Fig. 1 & 1a).
www.Hydrofarm.com
2
INSTRUCTIONS
2. Insert the shorter end of wire legs into the
clips individually. Take note that the legs
should be inserted from the clips side with
plastic screw (Figs. 2).
3. Insert the longer end of wire legs into the
holes on the two mounted plastic caps. Make
sure the end of the wire is inserted into the
cap completely, but can't be seen from the
other side (Fig. 3).
4. Insert the power cord into the light system.
(Fig. 4).
5. Mount the fixture on the 20-site oxyCLONE
system and tighten the screws clockwise
(Fig. 5).
Fig. 1a
Fig. 1
Fig. 2