Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing a quality unit. Used carefully and in accordance with the instructions set out below,
your SOLAR GARDEN LIGHT SYSTEM should give you many years of trouble free use. Please read the
instructions carefully to obtain the best results from your purchase.
Your units features:
Attractive ground stake & wall lamp-set
•
1 pc x 0,5 Watt LED (life up 100.000 hours)
•
Mono crystal solar panel
•
2m cable included
•
2 x solar rechargeable batteries (900 mAh AA Ni-Mh)
•
Light up to 8 hours as fully charged
•
Manual AUTO/OFF switch
•
Safe water resistant
•
Spotlight 6m
•
Location of the SOLAR CONTROLLER
1) For the best result, please locate the solar controller in a
position where it can get direct sunlight on the solar panel, and
generally free from cover and shade. (As shown in figure 1).
2) Make sure that the photo sensor is not going to be affected by any other light source. Otherwise the light will
not illuminate at dusk.
3) The SOLAR CONTROLLER must be left to charge for 2 sunny days before best results are achieved.
Assembly Instructions
Solar controller installation
1) Carefully remove the UNIT and all the fittings out of the box.
2) Assemble the mounting poles, and stakes; Push the stake directly into the ground
(DO NOT hammer the light or the stakes).
3) Slot the controller head on the upper part of the mounting poles carefully.
4) Adjust the switch under the Panel unit to "ON" position.
Instruction Manual –
-
Publicidad
Tabla de contenido
