Carton Contents; Overview (Fig. A) - Black and Decker GT650 Manual De Instrucciones

Fitting your own extension cable
When making your own extension cable,
fit a 13 Amp plug to one end of the cable
(see "Mains plug replacement") and a female
connector to the other end.
For wiring instructions, see those supplied with
the female connector.
A male connector (see below) is already
attached to the power supply cable on your
tool. It is non-rewireable and should not be
removed. If the connector is damaged and
needs replacement, take the tool to a
Black & Decker service centre.
female connector
Never wire an extension cable with
anything other than the female connector
supplied and a 13 Amp BS1363A
approved plug with the recommended
fuse. Never wire a male connector to the
extension cable. Never wire an extension
cable with a plug of any kind at each end
of the cable. This is extremely dangerous
and results in the pins being live, which
may cause a fatal electric shock.

CARTON CONTENTS

The carton contains:
1 Hedgetrimmer
1 Blade sheath
1 Guard
6 Screws
1 Instruction manual
Carefully unpack all parts.
Please note that additional items may be found
in the carton, depending on the letter suffix
following the catalogue number of your tool.

OVERVIEW (fig. A)

1. Front handle switch
2. Trigger switch
male connector
3. Lock-off button
4. Front handle
5. Locking knob for front handle
6. Guard
7. Locking handle for cassette
8. Handle cover
9. Blade
10. Blade cassette
11. Blade sheath
ASSEMBLY
Before assembly, make sure that the tool
is switched off and unplugged.
Fit the blade sheath over the blades.
You will need a number 2 Posidrive screwdriver for
assembly.
Fitting the front handle (fig. B1 - B3)
Loosen the locking knob (5) a few turns (fig. B1).
Slide the handle (4) into position (A).
Press the handle into the location on the
bottom of the tool (B).
Fit the handle cover (8) in place and secure it
with the 4 screws (12) supplied (fig. B2).
Set the front handle (4) to a comfortable
operating position (fig. B3).
Secure the handle by tightening the locking
knob (5).
Fitting the guard (fig. C)
Place the guard (6) onto the tool as shown.
Secure the guard using the two screws (13)
supplied.
Never use the tool without the guard.
Fitting the blade cassette (fig. D1 - D3)
Set the locking handle (7) to the unlocked
position (fig. D1).
Place the blade cassette (10) onto the motor
unit, aligning the 3 pins on the motor unit with
the holes in the cassette.
Set the locking handle to the locked position
(fig. D2) to secure the cassette (fig. D3).
E N G L I S H
11