Intended Use - Bosch GPL4 Instrucciones De Funcionamiento Y Seguridad

Use and care
Use the correct tool for your
application. The correct tool will do the
job better and safer.
Do not use the tool if the switch
does not turn it on and off. Any tool
that cannot be controlled with the
switch is dangerous and must
be repaired.
Store idle tool out of the reach of
children and do not allow persons
unfamiliar with the tool or these
instructions to operate the tool. Tools
are dangerous in the hands of
untrained users.
Maintain tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
operation. If damaged, tool repaired
before use. Many accidents are
caused by poorly maintained tools.
Use the tool, accessories, etc., in
accordance with these instructions
The tool is intended for the accurate transfer of plumb up, down, level, and
Inserting/Replacing the Battery
Use only alkaline batteries.
Open the battery cover 2 by pulling the
battery door towards back of tool. When
inserting, pay attention to the correct
polarity according to the representation
on the inside of the battery
compartment.
Always use batteries with the same
power rating and from the same
manufacturer.
and in the manner intended for the
particular type of tool, taking into
account the working conditions and
the work to be performed. Use of the
tool for operations different from those
intended could result in a
hazardous situation.
Have your tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the tool
is maintained.
Develop a periodic maintenance
schedule for tool. When cleaning a
tool be careful not to disassemble
any portion of the tool since internal
wires may be misplaced or pinched
or may be improperly mounted.
Certain cleaning agents such as
gasoline, carbon tetrachloride,
ammonia, etc. may damage
plastic parts.
SAVE THESE INSTRUCTIONS.

Intended Use

square point.
Preparation
For the proper disposal of the used
batteries, see the section
"Environmental Protection".
• Remove the batteries from the
tool when not using it for
extended periods. When storing for
extended periods, the batteries can
corrode and discharge themselves.
Low Battery Indicator
Laser blinks 8 times between 8 second
intervals.
-6-
Service