Description; Assembly; Powering On - Gemini WRX-900TOGO Manual Del Usuario

4
ENGLISH //

DESCRIPTION

The Gemini WRX-900TOGO Portable Line
Array Speaker System is an easily portable
speaker system comprised of (6) 2.75" glass
fi ber high-frequency drivers, an 8" high-
excursion low frequency driver, and dual
integrated amplifi ers. This easy-to-use system
is highly portable and produces incredible
high-fi delity sound with the kind of dispersion
only possible with an array. Perfect for artists,
entertainers, or DJs, the WRX-900TOGO
delivers pro PA performance in large or small
venues alike. With additional features like
integrated DSP, reverb eff ect, and Bluetooth
streaming, it's the ultimate entertainment
solution for any gathering.

ASSEMBLY

A. Subwoofer with integrated electronics for
all system components.
B./C. Two identical spacers with connectors
on bottom and top.
D. Column element with the speakers and a
connection on the bottom.
Once the subwoofer is placed in the desired
location, plug the spacers into the subwoofer
and then add the column element with the
speakers. Depending on the application, the
column element with the speakers can be
installed with only 0, 1 or 2 spacers on the
subwoofer.
WRX-900TOGO
PORTABLE RECHARGEABLE LINE ARRAY
SPEAKER SYSTEM

POWERING ON

Make sure the WRX-900TOGO is fully
assembled, any required inputs and
outputs are connected, and mains power is
connected. Turn all volumes down, then switch
POWER ON.
RECHARGE YOUR SPEAKER
ON DC POWER:
The WRX-900TOGO is
capable of operating
and charging from a
DC power source, like
your car's battery.
The power supply
should provide 12-
36VDC @ up to 60W
(maximum).
WITH AC IN POWER CORD:
Connect power from mains power to the
speaker.
CHECKING BATTERY STATUS
You can check the
internal battery
charging level on
the WRX-900TOGO,
on the back of the
unit. The "BATTERY
STATUS" panel is located in the lower right
corner, When powered on, the LEDs will light,
indicating the amount of charge left in the
unit.
CONNECTING EXTERNAL DEVICES
Before connecting an input device to the
WRX-900TOGO, please make sure all input
volumes and the master volume are turned
down.
WIRED MICROPHONES
Locate mixer channels 1 and 2 on the rear
panel of the unit. Both channels have a
"Combo Jack", allowing you to connect
either an XLR or 6.5mm TRS
cable to the input. Switch
the channel to MIC level and
connect your microphone.
Note: The WRX-900TOGO
does not supply phantom
power.
100-240V~50/60Hz
DC Connection
AC Connection