Stanley FATMAX SFMCL050 Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 31
ENGLISH
@
Warning! Fire hazard. Do not operate
worklight or charger near flammable liquids or
in gaseous or explosive atmospheres.
Internal sparks may ignite fumes causing
personal injury.
Do not expose light or charger to wet or damp areas. Do
u
not expose light or charger to rain or snow.
Do not wash light or charger with water or allow water to
u
get inside light or charger. Do not submerge light in water
at any time.
@
Caution! When not in use, place tool on its
side on a stable surface where it will not
cause a tripping or falling hazard. Some
tools with large battery packs will stand
upright on the battery pack but may be easily
knocked over.
Never view directly with optical instruments into the light
u
source.
The light source of this luminaire is not replaceable; when
u
the light source reaches its end of life the whole luminaire
shall be replaced.
The luminaire should be positioned so that prolonged
u
staring into the luminaire at a distance closer than 0.8 m is
not expected.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving parts.
u
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When using
u
any tool for prolonged periods ensure you take regular
breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Labels on tool
The following pictograms are shown on the tool:
:
Warning! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions listed below may result in electric
shock, fire and/or serious injury.
6
(Original instructions)
Do not stare at operating light source
Additional safety instructions for batteries and
chargers
Batteries (Not Supplied)
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
p
u
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers (Not Supplied)
Use your STANLEY FATMAX charger only to charge the
u
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$
Do not probe the charger.
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised STANLEY FATMAX Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On / Off button
2. Lens
3. Hang hook
4. Pivoting head
5. Accessory attachment location

Publicidad

Tabla de contenido
loading

Tabla de contenido