LUND Interceptor Instrucciones De Instalación página 3

Installation Steps
Clean two (2) outboard holes in the hood with alcohol
11
Attach two (2) brackets to hood using two (2)
13
Align hood shield with hood edge. Ensure that holes in hood shield
aligns with upper holes in bracket
15
NOTE: 2008 - up Sequoia and
2010 - up Tundra ONLY
Replace (5) existing white pins on backside of grill with longer
pins included in kit.
17
NOTE: Actual application may vary slightly from illustrations.
pad and allow to dry.
fasteners.
Wrap protective film over edge of hood as shown.
12
14
Attach hood shield to both brackets using screws.
Hood shield
Screw
16
Reinstall grill by aligning with holes in hood edge. Ensure that the
hood shield is BETWEEN the grill and the hood.
18
Page 3 of 4
Carefully lower hood.
NOTE: DO NOT over tighten
Bracket
X2