Fan Assembly. Pgs - Craftmade Ellington TAH52CB5 Guia De Instalacion

5. Fan Assembly.
Select the downrod you wish to use depending
on your ceiling height. (If you wish to use a
different length, you must purchase a matching
downrod of the desired length.)
If you do not wish to use the 6in. downrod, you
will need to remove the hanging ball from the
6in. downrod for use with the 12in. (or longer)
downrod. Loosen set screw on hanging ball and
remove pin and clip. Lower hanging ball and
remove stop pin. Slide hanging ball off the
original downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Loosen yoke set screws and nut at top of motor
housing. Remove pin and clip from downrod (if you
have not already done so). Slide downrod through
canopy and yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. Lower yoke cover to
motor housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
All manuals and user guides at all-guides.com
clip
electrical wiring
page 4
set screw
stop pin
hanging ball
pin
A
clip
set screw hole
B
downrod
canopy
yoke cover
yoke set screw
pin
motor housing