Canopy Assembly; Blade Assembly - Craftmade Ellington TAH52CB5 Guia De Instalacion

7. Canopy Assembly.

Raise canopy to hanging bracket, aligning
slotted holes in canopy with loosened screws
in hanging bracket. Twist canopy to lock.
Insert screws (with star washers) that were
previously removed (on page 3, Section 4)
and secure all screws with Phillips
screwdriver.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade plate up to blade, aligning posts in
blade plate with holes, in blade as shown,
and lower blade arm over blade holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw
holes and attach blade arm with lock
washers and blade arm screws. [Note: Use
slot located on switch housing plate for easy
access to motor screw holes with
screwdriver.] Before securing screws
permanently, repeat with remaining blade
arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
All manuals and user guides at all-guides.com
blade plate
lock washers and
blade arm screws
page 6
canopy
blade attachment
screws and washers
blade arm
motor housing
blade arm
switch housing plate
hanging
bracket
canopy
screws
blade
blade