Start Procedure; "Continuous" Operation Mode; Switch Device On; Automatic Defrost - Trotec TTK 40 E Manual De Instrucciones

Start procedure

Insert air filter
A.
B.

Switch device on

1. Ensure that the condensation tank is empty and
inserted correctly. Otherwise, the device will not
operate!
2. Insert the mains plug into a properly secured
mains power socket.
3. Check whether the operation indicator light (20)
lights up.
4. Check whether the condensation tank indicator
light (14) is out.
5. Switch on the device at the mains switch (21).
6. Regulate the room humidity level by using the
"Plus" (12) or "Minus" (15) buttons.
7. Regulate the device fan speed by pressing the
"FAN SPEED" button (19).
B - 7

"Continuous" operation mode

In continuous operation mode, the device dehumidi-
fies the air constantly, regardless of the humidity in
the air.
To start continuous operation mode, press the
"Minus" button (15) until "CO" is shown on the
display (13). The continuous indicator light (16) lights
up green.
Adjusting the operating time
1. Press the "TIMER" button (17) to set the operating
time of the device. Press the button again until the
indicator light corresponding to the operating time
you want is lit (2 or 4 hours). After the operating
time has passed, the device automatically switch-
es off.
2. To switch this function off, press the "TIMER"
button (17) again until both operating time indica-
tor lights (11) are off.

Automatic defrost

If the room temperature is below 15 °C, the evapora-
tor becomes covered in frost while dehumidifying. The
device then carries out an automatic defrost. The du-
ration of the defrost can vary.
• The automatic defrost is interrupted as soon as the
mains switch (21) is pressed or the "Plus" (12) or
"Minus" (15) buttons are pressed.
• Do not turn off the device during the automatic de-
frost. Do not remove the mains plug from the
mains socket.
Operating Manual – Dehumidifier TTK 40 E
GB