Storage Recommendations - Stanley FATMAX FMHT0-77421 Manual De Instrucciones

Storage Recommendations

• The best storage place is one that is cool and dry, and away
from direct sunlight and excess heat or cold.
• Long storage will not harm the battery pack or power supply.
Fully charge the inspection camera prior to long-term storage.
• Do not store the inspection camera in below freezing
temperature.
Components
The inspection camera provides the user with a minimally
invasive means to inspect hard to reach places. It includes
a 1 meter long illuminated camera wand with 4 adjustable LEDs,
multiple video output options, and accessories.
Figure A
Wand Connector
1
LCD Monitor
2
Camera/Handle
3
Battery Compartment
4
Door
Power/LED Brightness
5
Wheel
Camera Wand
6
LED Lens/Camera body
7
Camera Power Light
8
Power Port
9
Micro SD Card Slot
10
Key Button Description
• When in real-time monitoring mode
21
(Figure
display the setup screen.
• Press
Use as a toggle to highlight the previous
22
icon on a menu.
Use as a toggle to highlight the next
23
icon on a menu.
• Press
24
icon on a screen.
• When an image is displayed on
the screen, press
screen, (Figure
In real-time monitoring mode, press
25
Press
26
off the LCD monitor.
USB Port
11
Video Output Port
12
3.5 mm RCA Video Cable
17
Micro USB to USB Cable
18
Micro SD Card
19
Accessories (Figure D)
2 Hooks
13
Magnet
14
Mirror
15
Retaining Sleeve
16
), press to
F
to exit current screen.
to select the highlighted
to flip the
).
G
to take a photo.
for 3 seconds to power on/
When an image is displayed on the
27
screen, press
image size 1x, 1.5x, 2x, 2.5x, or 3x.
In real-time monitoring mode, press
28
videos (Figure
In real-time monitoring mode, press
29
again to stop recording.
Powering the Inspection Camera
Loading AA Batteries in the Handle
1. Pull open the battery compartment door on the bottom of
the handle (Figure
4
B
2. Insert four new, high-quality, name brand AA batteries, making
sure to position the - and + ends of each battery as noted inside
the battery compartment (Figure
3. Close the battery compartment door.
Charging the Monitor's Li-ion Battery
1. ALWAYS plug the power supply adapter (Figure
an appropriate power outlet FIRST (Figure
2. Plug the 5VDC charger into the power port on the side of
the LCD Monitor (Figure
If the internal battery does not charge properly:
1. Plug a lamp or other appliance into the same electrical
receptacle to make sure it is working.
2. See if the receptacle is connected to a light switch which
turns power off when you turn off the lights.
3. Move the power supply and tool to a location where the
surrounding air temperature is approximately 18 °- 24 °C.
4. If charging problems persist, take the tool and power supply
to your local service center.
to increase the
to access saved photos and
).
Q
to start recording. Press
).
).
B
20
C
).
C
).
9
A
GB
) into
9