SIOUX 2S2300SR Instrucciones Y Lista De Partes

INSTRUCTIONS & PARTS LIST FOR 2S2300SR, 2SY2300SR SKIN CLAMP RUNNER
Read and understand these instructions before operating this tool.
Everyone using, maintaining, changing accessories or working near this tool must read, understand and follow these Safety Instructions!
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure regulator, and
lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water and dirt which may have
accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10 mm) I.D. Extension hoses should be at least 3/8" (10 mm) I.D. Use couplings and fittings with at least 3/8"
(10mm) I.D.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not used, add .04 oz.
(1.2cc, 12 to 15 drops) of oil into the air inlet twice daily.
Lubricate the gearing every 100 hours of operation with SIOUX No. 1198 grease.
GENERAL OPERATION
This tool is used to install skin clamps that temporarily hold components together. Skin clamps are often called by other names, such as "Cleco
clamps", "Kwick-Loc", "Wedgelok", and sheet metal holders. To install skin clamps, place the nose piece of the tool over the outer body of skin clamp.
Engage the tool driver on the threaded 1/4" (6.4 mm) nut of the skin clamp. Pull the trigger and run the tool until it stalls. To remove the skin clamp,
follow the above procedure, but reverse the rotation of the tool.
Motor speed may be controlled by adjusting the slotted head screw on the top rear of the tool.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
July 1, 2003
Murphy, North Carolina, USA
Date and place of issues
250 Snap-on Drive • PO Box 1596 • Murphy, NC 28906 • USA • Phone: 828-835-9765 •www.siouxtools.com
Form ZCE649
SERIAL "C"
SAVE THESE INSTRUCTIONS!
WARNING
When used improperly power tools can create hazardous situations.
Improperly used power tools can cause injury or death.
SOUND AND VIBRATION READINGS
Catalog No. *Sound Pressure dBA
2S2300SR 73.18
2SY2300SR 73.18
*per PN8NTC1
DECLARATION OF CONFORMITY
2S2300SR, 2SY2300SR
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Gerald E. Seebeck
Name and position of issuer
Original
Instructions
*Sound Power dBA
84.7
84.7
*per PN8NTC1
President
Sioux Tools Inc.
1
Form ZCE649
Date 2003July28/D
Page 1 of 10
*Vibration m/s
2
Less Than 2.5
Less Than 2.5
*per ISO 8662
Signature of issuer
2003July28/D
Date