Safety Of Others; Residual Risks - DeWalt DCMST561 Traducido De Las Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
i ) Always ensure that the ventilation openings are kept
clear of debris.
Maintenance and storage
a ) Disconnect the machine from the power supply
(i.e. remove the plug from the mains, remove the
disabling device or removable battery) before
carrying out maintenance or cleaning work.
b ) Use only the manufacturer's recommended
replacement parts and accessories.
c ) Inspect and maintain the machine regularly. Have
the machine repaired only by an authorized repairer.
d ) When not in use, store the machine out of the reach
of children.
Additional Safety Instructions for
Grass Trimmers

WARNING: Cutting elements continue to rotate after the
motor is switched off.
Wear long trousers to protect your legs.
Before using the appliance, check that your cutting path
is free from sticks, stones, wire and any other obstacles.
Only use the appliance in the upright position, with the
cutting line near the ground. Never switch the appliance on
in any other position.
Move slowly when using the appliance. Be aware that
freshly cut grass is damp and slippery.
Do not work on steep slopes. Work across the face of slopes,
not up and down.
Never cross gravel paths or roads while the appliance
is running.
Never touch the cutting line while the appliance
is running.
Do not put the appliance down until the cutting line has
come to a complete stand still.
Use only the appropriate type of cutting line. Never use
metal cutting line or fishing line.
Be careful not to touch the line trimming blade.
Keep hands and feet away from the cutting line at all
times, especially when switching on the motor.
Before using the appliance and after any impact, check
for signs of wear or damage and repair as necessary.
Take care against injury from any device fitted for
trimming the filament line length. After extending new
cutter line always return the machine to its normal operating
position before switching on.
Close supervision is necessary when the appliance is
used near children.
This appliance is not intended for use by young or infirm
persons without supervision.
This appliance is not to be used as a toy.
Use in a dry location only. Do not allow the appliance to
become wet.
Do not immerse the appliance in water.
Do not open the body casing. There are not user-serviceable
parts inside
Do not operate the appliance in explosive atmospheres,
such as in the presence of flammable liquids, gases
or dust.
When the appliance is stored or transported in a
vehicle it should be placed in the boot or restrained to
prevent movement following sudden changes in speed
or direction.
When not in use, the appliance should be stored in a dry,
well ventilated place out of reach of children.
Children should not have access to stored appliances.

Safety of Others

This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children must be supervised to ensure that they do not
play with the appliance.
When the appliance is stored or transported in a
vehicle it should be placed in the boot or restrained to
prevent movement following sudden changes in speed
or direction.
When not in use, the appliance should be stored in a dry,
well ventilated place out of reach of children.
Children should not have access to stored appliances.

Residual Risks

In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
Impairment of hearing.
Risk of personal injury due to flying particles.
Risk of burns due to accessories becoming hot
during operation.
Risk of personal injury due to prolonged use.
SAVE THESE INSTRUCTIONS
Chargers
D
WALT chargers require no adjustment and are designed to be
e
as easy as possible to operate.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your D
WALT charger is double insulated in
e
accordance with EN60335; therefore no earth wire
is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
service organisation.
EngLIsh
WALT
e
29

Publicidad

Tabla de contenido
loading

Tabla de contenido