Three Wire Connection - Erreka LTBST Serie Instrucciones De Instalación

Decodificador para llaves de proximidad
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

-009/-500/1000
BASIC CONTROL PANEL
PROXIMITY KEYS DECODER
Warnings
The LTBST decoder is designed to decode the LTREA
proximity key reader signal, providing a potential-free relay
output.
Components
F1
Circuit protection cut-out (2.5A)
B1
Record buzzer
A long beep: the user key recording has been
activated using the master key
Two short beeps: a key has been correctly recorded
MEM Memory to store key codes
L1
Reader 1
L2
Reader 2
CM
Control panel
Characteristics of the device
• Power supply 230V, 50Hz
• Potential-free relay output (pulse signal, similar to a push
button)
• Protection against surges by way of cut-out and varistor
• IP56 protection grade (outdoor installation)
• Separate connecting strips for high and low tension.
Install the decoder only to fulfil the functions
described in these instructions. Inappropriate use
may lead to failures and hazardous situations.
Twin wire connection

Three wire connection

Controls and indicators
SW
Key recording microswitch
DIP1=OFF and DIP2=OFF: operation mode
DIP1=ON and DIP2=OFF: user keys recording
DIP1=OFF and DIP2=ON: first master key recording
DIP1=ON and DIP2=ON: second master key
recording
DL1
Power supply
DL2
RUN (reader signal)
DL3
RL1 (relay activated)
• Possibility of connecting up to two readers with just two
wires (supply output with modulation detector)
• Possibility of storing up to 1000 keys (LTBST-009: 250
keys; LTBST-500: 500 keys; LTBST1000: 1000 keys) in line
with the memory inserted (standard roller type)
• Possibility of recording one or two master keys to record
new keys without opening the module
English
LTBST proximity keys decoder
5

Publicidad

Tabla de contenido
loading

Tabla de contenido