Assembling Your Kickscooter; Installing A Second Battery Pack (Optional) - Segway Ninebot KickScooter Manual Del Usuario

4 Assembling Your KickScooter

1. Unfold the stem and push it until you hear a
click. Flip up the folding pedal. Then unfold
the kickstand to support the scooter.
Note: Confirm that the latching axis on the
folding mechanism is secured correctly.
3. Install six screws (two on each side) with the
included hex wrench.
06
2. Firmly connect the wires inside the handle and
the stem. Slide the handle onto the stem. Be
aware of the correct orientation.
Head Light
toward front
4. Verify that your KickScooter powers on and off.

5 Installing a Second Battery Pack (optional)

Follow these steps when installing a second battery pack:
1. Remove the three screws on the stem, as shown.
Then remove the cover near the charge port and
remove the M3 screw.
3. Install the external battery on the rail and fix it with the M4 (20mm)
screws (2 pcs) and M3 screw (1 pcs), provided with this product.
After they are properly installed, block the screw holes with the
rubber stopper.
Warning: please use the screws provided with
this product only.
2. Install the rail with the M4 (10mm) screws (3
pcs), provided with this product. Please make
sure it is properly fixed.
4. Verify that your KickScooter powers on and off.
07