Controls; Brake Pedal; Forward Gear Pedal; Reverse Gear Pedal - Stiga TC-TS-TX-TH 102 Serie Traducción Del Manual Original

Tabla de contenido

Publicidad

4. Insert the cotter pin (fig. 12.E) into 
the hole (fig. D.1) on the pin (fig. 12.D) 
and rotate the pin in order to bend
the two ends (fig. 12.E.1) of the cotter 
pin, (with the aid of a pair of pliers), 
so that it cannot slide out, causing
the pin (fig. 12.D) to disengage.
Check that the spring works
correctly and keep the side dumping
chute securely lowered. Make sure
that the pin is fitted properly to prevent
it from falling out accidentally.

5. CONTROLS

5.1 BRAKE PEDAL

This pedal operates the brakes on 
the rear wheels (fig. 13.A, 14.A)

5.2 FORWARD GEAR PEDAL

This pedal is used to apply traction to the 
wheels and regulate the speed of the machine 
when it is moving forward (fig. 13.B, 14.B):
1. Forward drive gear. Increasing
the pressure on the pedal
progressively increases the 
speed of the machine.
2. Neutral position. The pedal
automatically goes into neutral 
position when released.
N.B. The "Neutral" condition is
indicated by the lamp (fig. 16.F).
N.B. If the operator presses the pedal while the
parking brake (fig. 13.D) is on, the engine stops.
5.3

REVERSE GEAR PEDAL

This pedal is used to apply traction to 
the wheels in reverse, and regulate the 
speed of the machine (fig. 13.C, 14.C):
1. Reverse gear. Increasing
2. Neutral position. The pedal
N.B. The "Neutral" condition is
indicated by the lamp (fig. 16.F).
N.B. If the operator presses the pedal while the
parking brake (fig. 15.D) is on, the engine stops.
5.4 HYDROSTATIC DRIVE
RELEASE COMMAND
This command has two positions, as 
indicated on the label (fig. 13.D, 14.D):
1. Drive engaged : for all uses,
2. Drive disengaged : this
IMPORTANT To avoid damaging the drive
unit, perform this operation only when the
engine is stopped and the pedals (fig. 13.B,
13.C, 14.B, 14.C) are in the neutral position.
• 4WD model only
The machine may only be moved easily 
backwards, even if the rear drive is released.

5.5 KEY IGNITION SWITCH

The key enables/disables the machine ignition
It has three positions (fig. 15.A):
1. Stop position. The machine 
turns off immediately.
2. On position. All functions are active.
3. Start position. Switch on the 
starter motor to start the machine. 
If you release the key on start it 
will automatically return to On.
EN - 10
the pressure on the pedal
progressively increases the 
speed of the machine.
Reverse must only
be engaged when the
machine has stopped.
automatically goes into neutral 
position when released.
when moving and during cutting.
makes it much easier to move 
the machine by hand, with 
the engineturnedoff.

Publicidad

Tabla de contenido
loading

Tabla de contenido