(En); Introduction And General Description - Telwin DRIVE 9000 Manual De Instrucciones

INSTRUCTION MANUAL
WARNING: READ THE INSTRUCTION MANUAL CAREFULLY
BEFORE USING THE STARTER!
1. GENERAL SAFETY USER INSTRUCTIONS FOR THIS
STARTER
In order to reduce the risk of personal injury and damage
to equipment, it is highly recommended to comply with all
essential safety measures and precautions when using the
starter.
- Inexperienced and untrained personnel should be properly
instructed before using the appliance.
- Children must be supervised to prevent them from playing
with the appliance.
- Protect the eyes. Always wear protective goggles when
using acid lead accumulators.
- Avoid contact with battery acid. If an operator should
be sprayed or come into contact with the acid, rinse the
relative parts immediately under clean running water.
Continue to rinse the area until the physician arrives.
- It is important to connect the cables with the poles in
the right direction:
First connect the red clamp to the positive terminal on
the vehicle battery (+ symbol).
Connect the black clamp to the vehicle chassis, at a distance
from the battery and the fuel pipe.
- Use the starter in well ventilated areas. Do not attempt to use
the starter when there is gas or inflammable liquids in the
vicinity.
- Make sure that the black and red clamps never come into
contact with each other as this could cause them to fuse
together or with other metal objects. Return the clamps to their
respective housing.
- FOR 12 VOLT SYSTEMS ONLY! This device is destined for use
on vehicles running on 12 Volt electrical systems only.
- USE IN EMERGENCY SITUATIONS ONLY: do not use the
starter instead of the vehicle battery. Use it during start-up
operations only.
- Do not work alone. If there is an accident, the assistant can be of
aid to the operator.
- Prevent electrical shocks. Be very cautious when
applying the clamps to non-insulated conductors or bus
bars. Avoid all body contact with surfaces of tubes,
radiators, and metal power substations whilst testing the voltage.
- Keep the work area clean at all times. Untidy cumbersome areas
can lead to injuries.
- Protect the starter appropriately from all possible damage. It
must only be used as indicated in this Instruction Manual.
- Ensure compliance with the indications in the work area. Do
not use in humid or wet facilities. Never leave it out in the rain.
Always work in well lit areas.
Keep out of reach of children: they must never be
-
allowed to access work areas or handle any
machines, instruments or extensions.
Always wear suitable clothing. Never wear baggy
-
clothing or jewellery that can get caught up in
moving parts. During all operations, the use of
electrically insulated protection clothing and non-slip boots
must be worn at all times. Persons with long hair must tie it
back and wear a hair net.
- Only experts are allowed to do repair work on the starter as it
involves significant risk levels for inexperienced workers.
- Replacing parts and accessories. When performing maintenance
operations, replace with identical spare parts only. Use of non-
original spare parts invalidates all warranties.
- Make sure that the device is always positioned in a stable and
well supported manner.
Never climb over cables or electrical structures.
- Careful attention must be paid during maintaining work on

(EN)

the starter. Check the condition of cables on a regular basis
and if any damage is detected, have the same repaired by an
authorised and qualified technician.
- Check there are no damaged parts. Before using this starter,
carefully check that all seemingly damaged parts and assess
whether or not they can operate correctly. Check that the
cables are securely fastened to the starter. Remember that only
authorised and qualified technicians are allowed to repair or
replace damaged parts.
1.1 SPECIAL WARNINGS AND SAFETY PRECAUTIONS ON
THE USE OF THE LITHIUM BATTERIES INSIDE THE STARTER
Failure to observe the following rules can cause breakage,
overheating, bulging, fire outbreak or explosion of the battery
inside the starter:
- Never open the starter casing under any circumstances.
- Do not charge the battery in direct sunlight, near flames or in
similar conditions.
- Do not use the starter or position it in the vicinity of heaters, near
flames or in other hot areas.
- Only use the charger supplied with the device to charge the
starter.
- Do not throw the starter into a fire or heat it up.
- Do not invert the positive "+" and negative "-" connection
polarities.
- Do not short-circuit the starter terminals.
- Do not perforate the starter casing with drill bits, do not hit it with
a hammer or stand on it.
- Do not position the starter inside stoves, microwave ovens etc.
- Do not throw the starter or cause high impacts.
- Do not modify or tamper with the starter casing.
- Refrain from using the starter if it emits strange smells, heats up
or deforms during use, charging or storage.
- If the starter emits strange smells or leaks acid, immediately
move the device away from any heat sources or free burning
flames.
- In case of contact of the starter battery acid on the skin or
clothing, rinse with copious amounts of water.
- In case of contact of the starter battery acid with the eyes, rinse
immediately with copious amounts of water and call a doctor.
Keeping this manual.
The manual should be read, paying attention to all the warnings
and safety precautions to be taken when using and maintaining
the device, the list of components and all technical specifications.
Please keep this manual in a secure and dry place for future
reference.

2. INTRODUCTION AND GENERAL DESCRIPTION

Intended use
Multi-functional, portable, battery-powered starter. Ideal for anyone
needing an emergency starter. Its applications include use on
motorcycles, automobiles, boats and many more.
Fully compatible with any 12-volt starter system.
The starter uses LITHIUM BATTERIES; this makes the device
extremely compact and easy to handle.
The multi-functional starter is also equipped with a powerful
LED light and four outputs to power and/or charge 5V/12V/19V
electronic devices.
Description (figure A):
A-1. Book type pack.
A-2. Multifunctional starter.
A-3. Starter clamps.
A-4. 12V/10A and 19V/3.5A output cable.
A-5. Charger cable with cigarette lighter type 12V jack plug.
A-6. Adaptor cable to connect the USB port on the device
to various power and/or charge inputs on the main
commercially available electronic devices.
A-7. Output adaptors for the A-4 cable.
A-8. Charging power unit.
A-9. Starter charging input.
A-10. 12V/10A output.
A-11. 5V/1A and 5V/2.1A USB ports.
A-12. 19V/3.5A output.
A-13. LED lights.
A-14. Starter clamps outs (ref. A-3).
- 3 -