Handle Assembly - Sears Kenmore 116.38099 Manual Del Propietário

Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts LisL Use this list to verify that
you have received all the components of
your new Kenmore vacuum_
E
• wAR. .G . ...................
Electrical Shock Hazard
Do not plug into the electrical sup-
ply until the assembly is complete,
Failure to do so could result in elec-
trical shock or injury.
HANDLE ASSEMBLY
Remove the screw located just below the
top edge of the back of the vacuum.
Position the handle as shown in the illustra-
tion below.
While holding the power cord out of the way,
slide the handle into the opening at the top
of the vacuum.
Handle
,@
Handle
Screw
Hole
Insert the screw so it passes through the
handle into the vacuum.
!
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle
slightly.