Agitator Assembly - Sears Kenmore 116.24212 Manual Del Propietário

TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum,
the agitator must be cleaned every time th_
belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vf_¢uum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean A aitatqr
every week
every month
every 2 months
IMPORTANT
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the Power_Mate _ agitator
and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
Agitator Assembly
BeR
Pulley
Brush
TO REPLACE BELT
1. Install
new belt
over motor
drive, then
over brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for Belt #.
Brush
Suppo_
D_ve
Brush
Brush Sprocket
2. Snap brush
supports into
place on base.
Be sure brush
supports are
not upside-
down.
3, Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown.
Cover
Base
4. Rotate cover
back. Press
cover firmly until
side tabs snap
into place.
Replace cover
screws, light
bulb and light
cover.
16