Master/Slave Mode (Cont.); Configuration (Dmx); Dmx Personality And Starting Address; Custom Color Adjustment - Chauvet DJ Gig BAR IRC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

For the master:
Master/Slave
1.
Mode (Cont.)
2.
· Make sure the master is the first unit in the DMX chain.
· Never connect a DMX controller to a DMX chain configured for Master/Slave operation
· Do not connect more than 31 slaves to the master.
Configuration
Set the product in DMX mode to control with a DMX controller. The product uses a 3-pin DMX
cable.
(DMX)
1.
2.
When selecting a DMX starting address, always consider the number of DMX channels used by
DMX Personality
the fixture. If you choose a starting address that is too high, you could restrict the access to
and Starting
some of the product's channels.
Address
The GigBAR™ IRC uses 3-, 9- and 20-channel DMX personalities, which means the highest
DMX address you can use is 493.
If you are not familiar with the DMX protocol, download the DMX Primer from
http://www.chauvetlighting.com/downloads/DMX_Primer_Rev6_WO.pdf.
To select the DMX personality and starting DMX address, do the following:
1.
2.
3.
4.
Custom Color
To set both the Par and Derby to a custom color, do the following:
1.
Adjustment
2.
3.
4.
5.
6.
7.
GigBAR™ IRC User Manual Rev. 3
All manuals and user guides at all-guides.com
Connect the DMX output of the master to the DMX input of the first slave unit.
Set the master unit to operate in either Automatic or Sound-Active mode.
because the controller may interfere with the signals from the master.
Connect the product to a suitable power outlet.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket
on the product.
Press <MENU> repeatedly until the desired DMX personality (3 CH, 9 CH, or 20CH) blinks
on the display.
Press <ENTER> and D** blinks on the display.
Use <UP> or <DOWN> to select the starting address (d001–d512).
Press <ENTER> to put the fixture in DMX mode. The display will continue to blink.
Press <MENU> repeatedly until CoLo blinks on the display.
Press <ENTER>.
Use <UP> or <DOWN> to scroll through R** (red), G** (green), or B** (blue).
Press <ENTER> to select the color.
Use <UP> or <DOWN> to adjust the color saturation (X000–X255).
Press <ENTER>.
Repeat Steps 3 through 5 for each color.
Page 21 of 96

Publicidad

Tabla de contenido
loading

Tabla de contenido