Kohler 1108711 Manual De Instrucciones

SERVICE KIT INSTRUCTIONS
Plug Button
Dome
Screw
Washer
Handle
Bonnet
Remove
Turn off the water supply. Lift the handle to relieve the water pressure.
Identify your handle type in the illustration, then disassemble the faucet according to the illustration.
Turn the bonnet counterclockwise to remove it from the faucet body.
Mark the limit stop on the valve to ensure correct realignment.
Slide the limit stop off of the valve spline.
Turn the mounting nut counterclockwise to remove it from the faucet body.
Extract and discard the vacuum breaker (not shown), check valve with O-ring, and seal from the
faucet body.
Install
Place the new seal into the faucet body.
Insert the O-ring end of the new check valve into the new spacer.
Properly seat the new spacer on the seal in the faucet body.
Securely wrench tighten the mounting nut to the faucet body.
Press the limit stop on the valve spline, then position the limit stop at the mark on the valve.
Securely hand tighten the bonnet.
Reinstall the handle.
Turn on the water supply. Check for leaks and proper operation.
1112263-9-A
Handle
Plug
Button
Screw
Screw
Handle
Bonnet
Bonnet
O-Ring
Setscrew
Handle
Screw
Bonnet
Bonnet
Mounting Nut
Valve
Seal
Seal
Faucet
Body
SPACER ASSEMBLY KIT
1108711
Handle
O-Ring
Setscrew
Plug
Button
Plug Button
Limit Stop
Valve Spline
Spacer
Check Valve
with O-ring
©2009 Kohler Co.