Publicidad
M.-Nr. 09469886
Risk of injury due to incorrect fitting
WARNING
Risk of accident if machine tips over.
A
The plinth may only be used with Miele machines.
A
The plinth must not be used with integrated models or a washer-dryer stack combination.
A
Fasten the washing machine to the plinth.
A
With a combination with one or more other plinths, individual plinths must be connected together with the
connection pieces.
A
With a single machine installation, secure the plinth to the floor with the floor fastening fitting kit,
Mat. no. 06593051.
A
At least two plinth feet must be bolted to the floor and at least one of these should be at the rear. Fastening of two
diagonally opposite feet is ideal.
Danger due to unsuitable materials in the plinth drawer
DANGER
A
Do not store any inflammable items in the drawer.
NOTE
Wooden parts may swell and/or warp.
A
Do not store any damp or wet items in the drawer.
Plinth fitting
Removal of drawer from plinth
A
Pull out the drawer fully, see Fig. 2.
A
Press the spring catches and at the same time lift the drawer upwards, see Fig. 3.
Fitting the plinth under a tumble dryer
A
Empty the condensate container drawer.
A
Screw the dryer feet in fully with a pipe wrench.
A
Remove the threaded pins from the plinth with a 5 mm Allen key (A) and dispose of them, see Fig. 4.
A
Fit the 10 x 40 mm threaded pins supplied as far as possible into the threaded bolts (B), see Fig. 4.
WARNING
Risk of crushing fingers if they are trapped between the dryer casing and the threaded pins.
A
Do not lift the dryer at the corners.
A
Lift the dryer onto the plinth and guide the threaded pins into the openings in the dryer feet, see Fig. 5.
A
Fit the sealing strips as shown on the inside of the rear panel, see Fig. 6.
A
Loosen the screws on the eccentric cam (1) on the dryer rear panel, see Fig. 7
The eccentric cams may move slightly when the screws are loosened. To ensure safe installation, the eccentric cams
must be returned to the starting position: Engaging tooth in the bottom left at a 20° angle (1), see Fig. 7.
A
Use 1 CEM 4 x 10 raised-head screw to fit the rear panel on the plinth at the bottom (2), see Fig. 7.
A
Hook the connection pieces (3) onto the screws on the eccentric cams, see Fig. 7.
A
Use 2 CEM 4 x 10 raised-head screws to fit the connection pieces and the rear panel on the plinth at the top (1),
see Fig. 8.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
19 von 83
26.02.2021
Publicidad
