Publicidad
M.-Nr. 09469886
Front panel adjustment
The machine front and the front panel of the drawer must be in line with each other. After installation, it may be
necessary to adjust the drawer front panel to align it. The height and tilt angle of the drawer front panel can be adjusted.
A
Open the drawer.
A
Adjust the height of the front panel:
- Remove the caps (A), see Fig. 13.
- To adjust the height, turn the adjustment wheels on either side as appropriate (B).
- After adjustment, refit the caps.
A
Adjust the tilt angle of the front panel:
- To adjust the angle, twist the drawer rods as appropriate, see Fig. 14.
A
Close the drawer.
When installing machines next to each other: connect the plinths
A
Place the plinths next to each other.
A
Loosen the counter nuts on all plinth feet.
A
Twist out the connection pieces.
A
Place the connection pieces with their openings on the plinth feet but don't secure them with the counter nuts yet.
The two connected plinths must align with each other at the front.
Plinth feet adjustment
A
Check with the spirit level.
A
Adjust the plinth feet as appropriate until the plinth is level; see Fig. 15.
A
With a combination with one or more other plinths: ensure all plinths are the same height.
A
Tighten all counter nuts.
en
cs
Sokl se zásuvkou pro automatické pračky a sušičky WTS510/APCL041
Potřebné díly
Počet
č. m.
Název
1
09322300
montážní sada WTS510
1
11477320
montážní sada APCL041
Obsažené díly
Počet
č. m.
Název
1
montážní návod
1
sokl WTS510/APCL041
1
zadní stěna soklu
2
spojovací díl
4
distanční objímka
3
šroub s čočkovou hlavou CEM 4x10
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
21 von 83
26.02.2021
Publicidad
