Echo 99944200250 Instrucciones página 2

2
NYLON LINE REPLACEMENT
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Hold head firmly and push in cover tabs (A) to remove cover (B) and
spool (C). Assure spring remains in housing.
3. Use one piece of new nylon line (D) 15 m (50 ft.) long and thread
through the molded loop (E) on the spool. Pull line tight and adjust so
one end is 15 cm (6 in.) longer than the other.
4. Hold spool with the tap knob in your hand and opening toward you.
Place index finger between the two lines, and wind line clockwise
tightly and evenly.
NYLON LINE HEAD INSTRUCTIONS
A
B
C
E
D