Technical Data; Components Available - Marmitek PRO SYSTEM 200 Modo De Empleo

5. TECHNICAL DATA

IR System Module
Supply Power:
Power STATUS:
IR LED:
IR LED/Blaster:
IR Receiver connection:
Dimensions:

6. COMPONENTS AVAILABLE

IR Receivers
Each system needs a minimum of one IR Receiver (maximum of 3). You can use
an extra IR Receiver to operate your A/V equipment from another room. See
datasheets for the IR Receivers on www.marmitek.com.
Dual-band IR Receivers
New, disruption-suppressing technology for use in the vicinity of Flat Screens
(such as Plasma, LCD and LED screens), direct sunlight and energy-saving bulbs.
Art.nr. 08003 - IRR3856S (separate receiver)
Art.nr. 08004 - IRR3856P (built-in receiver)
Broadband IR Receivers
Broadband Receiver 30 – 90 kHz is suitable for almost every brand and model of
A/V equipment.
Art.nr. 09734 - IRR3099S (separate receiver)
Art.nr. 09733 - IRR3099P (built-in receiver)
Art.nr. 08005 - IRR3099T (Table-TOP receiver)
IR LEDs (1 or 2 LEDs per cable)
Each system needs a minimum of one IR Extender Cable (maximum 4). The IR
Extender Cables with LEDs must be stuck to the A/V device that you wish to ope-
rate. The blinking LED version lights up if you send an infrared command with
the remote control. The non-blinking LED just passes the command onto the
device but does not light up.
Art.nr. 09777 - IRCP blinking 2 LED
Art.nr. 09843 - IRCP non-blinking 2 LED
Art.nr. 08007 - IRCP blinking 1 LED
Art.nr. 08008 - IRCP non-blinking 1 LED
You can use IR LEDs to operate a maximum of 8 A/V devices (4x IR Extender
Cables with 2 LEDs)
See datasheet for the IR LEDs on www.marmitek.com.
IRCP System Module 200™
100-240VAC 50/60Hz, 12VDC 1.2A (supplied)
12VDC 200mA. plug, - 5.5mm outside /
+ 2.1mm inside (not supplied)
2x 3.5mm mini jack plug (mono)
2x 3.5mm mini jack plug (mono)
1 Connector for a maximum of 3 parallel
connected IR Receivers. Extendable up to
300 metres via CAT5 (or equivalent)
79 x 52 x 26mm
7