Craftsman 183.172521 Manual Del Propietário página 2

SECTION PAGE
Warranty ........................................ 2
Product Specifications ...................... 2
Power Tool Safety ............................ 3
Cutting Tool Safety ........................... 4
Electrical Requirements & Safety ........ 5
Accessories .................................... 6
SECTION PAGE
Carton Contents .............................. 6, 7
Know Your Cutting Tool .................... 8
Assembly & Operation ...................... 9 - 18
Maintenance ................................... 18
Repair Parts ................................... 19 - 25
Parts & Service Availability ................ 26
FULL ONE YEAR WARRANTY
tf this Cutting Tool fails due to a defect in material or workmanshipwithin one year of date of
purchase,Sears will at itsoptionrepairor replace it free of charge.
Return this Cutting Tool to a Sears Service Center for repair, or to place of purchase for
replacement.
This warrantygivesyou specificlegal rights,and youmay also have other rights whichmay vary
from state to state.
Sears, Roebuckand Co., Dept. 817 WA, Hoffman Estates, IL 60179
IA WARNING I
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
,, Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your expos,
to these chemicals, work in a well ventilated area and work with approved safety equipment such as those dust
masks that are specially designed to filter out microscopic particles.
Motor Rating ...................... 120V, 60Hz, AC Motor Horsepower ...... 314HP (Maximum Developed)
Amperes ........................... 5.0 Amperes Weight ..................... 1.7 kg
2 Speeds (no load) .............. 20000 & 30000 RPM
IJk WARNING I
To avoid electrical hazards, fire hazards or damage to the cutting tool, use proper circuit protection.
This cutting tool is wired at the factory for 110-t20 Volt operation. It must be connected to a 110-120 Volt / 15
Ampere time delay fuse or curcuit breaker. To avoid shock or fire, replace power cord immediately if it is worn,
or damaged in any way.
Before using your cutting tool, it is critical that you read and understand these safety rules. Failure to follow th_
rules could result in serious injury to you or damage to the cutting tool.