Technical Specifications - Turtle Beach EARFORCE X42 Manual Del Usuario

Tabla de contenido

Publicidad

Troubleshooting
No sound
• Check that the headset volume control is turned up.
• Check that the transmitter power and optical cables are properly connected.
• Check that the headset is powered on. The LED on the left ear cup should be flashing.
• Check if the Power LED on the transmitter is on solid. If the LED is slowly pulsing, it indicates that the transmitter isn't
communicating with the headset. If the headset is on solid and the transmitter LED is slowly pulsing, then the headset and transmitter need
to be "paired" as described in the section "Pairing the Headset and Transmitter" (see pg 4).
Audio Drops, Popping or Clicking Sounds
Audio dropouts, popping or clicking sounds on the headset are caused by poor reception. This can occur when:
• The headset and transmitter are out of range. For best performance, move within 20 feet from the transmitter.
• There's a wall or other large object between the headset and transmitter.
• The transmitter is in a bad location that is interfering with the antenna.
• A wireless base station or wireless LAN are causing a lot of RF activity that's blocking the RF signal from the transmitter. The transmitter
should be moved at least 5 feet away from a wireless router or gaming console.
Voice Chat Drops
• Most in-game voice chat drops are simply caused by network performance or "lag". Usually they subside after a few moments so please
be patient. In extreme cases, you may have to leave a game and return to reset the chat function.
• If you use a wireless internet connection, low signal strength from your modem/router can make the voice chat malfunction.
A wired connection from your modem/router to your console is recommended for best results.

Technical Specifications

Headset
· 50mm diameter speakers with neodymium magnets
· Game audio frequency response: 20Hz - 20kHz, >120dB SPL @ 1kHz
· Condenser microphone frequency response: 50Hz - 15kHz
Game audio Dual Band WiFi Digital 2.4GHz/5.8GHz RF wireless
·
· Headphone amplifier: Stereo 27mW/ch, THD <1%
· Operates on (2) AAA batteries or (2) AAA rechargeable NiMH batteries
· Automatic shut down after approx 5 minutes of carrier loss or audio
silence to conserve battery power
· Battery booster circuit extends battery life for up to 15 hours
Transmitter
WiFi Digital 2.4GHz/5.8GHz
· Dual Band Digital
transmission with up to 30 foot range
· Frequency response: 20Hz - 20kHz
· Optical TOSLINK digital audio input compatible with 48kHz digital
audio stream
· Optical TOSLINK digital audio output pass-through of digital
input stream
· Stereo 3.5mm analog input jack
· Maximum analog input level: 2Vpp (700mV rms)
· USB Power – (5V DC @ 350mA max)
wireless
14

Publicidad

Tabla de contenido
loading

Tabla de contenido