Installing The Sensor - 70mai MIDRIVET01 Manual Del Usuario

Installing the Sensor

1. Remove the four tires separately. Deflate
them and remove the original tire nozzle.
(When removing the tires, pay attention to
their original location so that they can be put
back to their original position. After
removing the nozzles, clean the nozzle hole
on the wheel hubs with detergent.)
2. Remove the dust cap and tightening nut of
the sensors.
3. Install the sensors to the nozzle hole of the
wheel hubs according to the sensors' serial
number. (Ensure that the electronic module
of the sensors is parallel to the wheel hub to
maintain continuous operation and
accuracy.) Secure the sensors to the nozzles
using the tightening nuts.
Note:
The torque of the tightening nut should be 3-5 N • m.
1５