G-Systems ED11-201EU Manual De Instrucciones página 21

Activate you warranty online http://g-systems.eu/warranty/
min.
You find these three buttons on the fan controller UP, DOWN and SAVE/SET.
With the buttons UP and DOWN you can navigate through the single settings.
To change the temperature value push the SET/SAVE button once. The settings
start to blink, now you can change the value with the UP and DOWN buttons.
Set the desired temperature for the day time indicated with the sun symbol.
Push again SET/SAVE to save the setting and return to the selection of settings.
max .
The power LED blinks and the fan
starts to initialize This takes a few
seconds. As first you will see a
screen with all the LCD segments
and back-light working.
Next it starts initializing the sensor
and in case this screen stays at
this stage, there is a mistake with
the sensor or the communication it
self. You have to return the fan for
repair.
Otherwise you will find in a few
seconds the the measured value,
fan speed bar and day/night stage.
set
save
If you press DOWN once you will
find the temperature day setting.
This setting you will see for about
10sec. and then it goes
automatically back to the home
position and the back-light stops
working.
EN
19