BH FITNESS YF 90 Manual De Instrucciones página 5

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES.
To fit the batteries, remove the rear
cover on the monitor, Fig.1, and
carefully insert the two "R-6" type
batteries into the battery compartment
making sure that the battery's polarity
is correct (matching the battery's «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign). Close the
cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if
motionless for 4 minutes.
Important. Discarded batteries must
be deposited in special containers,
Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
Fit the monitor (14) into the boss on
the bracket (12), as shown in Fig.4,
connect terminal (5) on the middle
cable to terminal (B) for the monitor,
Fig.4A.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
uses two 1.5
the unit remains
of speed,
English
distance,
calories burnt.
volt
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
A. SCAN FUNCTION.-
In Scan
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the Scan function:
1. The monitor starts in Scan mode as
soon as exercise begins or if any key
is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, values every 6 seconds.
2. Press the Mode/Reset key and this
will cancel the Scan function.
B. TIME FUNCTION.-
This function counts up in steps of one
second, up to a maximum of 99:59
minutes. Pressing the RESET key for
more than two seconds will reset all of
the values.
1. Press any key to switch the monitor
on.
C. DISTANCE FUNCTION.-
This function counts up in steps of
0.01km, up to a maximum of 99.9km.
Pressing the RESET key for more
than two seconds will reset all of the
values.
1. Press any key to switch the monitor
on.
5
speed, exercise
mode the
time,
computer