Transport, Packaging And Storage; Transport; Packaging; Storage - WIK GA11 Manual De Instrucciones

4. Transport, packaging and storage / 5. Commissioning, ...

4. Transport, packaging and storage

4.1 Transport

Check the analytic instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
EN

4.2 Packaging

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g.
calibration, sending for repair).

4.3 Storage

Permissible conditions at the place of storage:
Storage temperature: -20 ... +60 °C
Air humidity: 15 ... 90 % r. h. (non-condensing)
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Storage outdoors or in humid environment
■
Unauthorized access
■

5. Commissioning, operation

Depending on the version of the analytic instrument, the user interface may
differ from those illustrated in these operating instructions. However, the
procedure is always the same.

5.1 Battery/mains operated

The analytic instrument can be operated in battery mode and in the mains supply.
If the lithium-ion rechargeable battery is fully charged, the analytic instrument can
perform at least 5 measurements with the "back pumping" function. The number of the
battery-powered pump-back cycles is largely dependent on the container pressure of the
gas to be measured.
The GA11 sends a warning message on the display when battery is low.
If the instrument is not connected to the mains in time, it will shut down automatically in order
to prevent damages and data loss. In the mains operation, the battery is charged and the
instrument can be switched on again at the same time and operate without restrictions.
14 WIKA operating instructions analytic instrument, model GA11