Input, Output And Control Section - dBTechnologies DVA MINI G2 Manual Del Usuario

English

INPUT, OUTPUT AND CONTROL SECTION

1. AUDIO INPUT AND OUTPUT LINK (BALANCED)
Balanced XLR connector that allows connecting
a line INPUT. A similar type of connector is used
to link the output signal to a second module
(OUTPUT LINK)
2. DSP PRESET
It allows setting the necessary optimisation of
high frequencies in line arrays depending on the
distance and number of modules.
3. RDNet DATA IN and RDNet DATA OUT
RDNet data input and output compatible with
network cables fitted with etherCON/RJ45 type
connectors.
"Data in" must be connected to devices such as
RDNet Control 2 or Control 8.
"Data Out" is used to link the network to other
loudspeakers in daisy-chain configuration.
4. RDNet CONTROL LEDs
LEDs relating to module network operation
(RDNet).
In particular, if "Link" is on the RDNet network
is active and has acknowledged the device,
if "Active" is flashing there is data traffic, if
"Remote Preset Active" is on all local control on
the amplifier panel are by-passed by the RDNet
remote control.
5. STATUS LED Main
LEDs show monitor status indications at a glance,
according to the logic summarised in the table
below:
DVA MINI G2
RDNet
Data In
3
Data Out
Link Limiter
4
Active Signal
USER /
Status
SERVICE
Remote
Preset
HF1
ON
Active
HF2
5
HF3
FRONT
more than
6 boxes
DSP Preset
SERVICE DATA USB PORT
This standard USB Type-B port enables user to update product
firmware using a PC and USB BURNER MANAGER. More details are
available at http://www.dbtechnologies.com under "DOWNLOADS"
and in section FIRMWARE
Balanced Audio
Input
Output
Link
DESIGNED & DEVELOPED
USB Data
Service
HF1
HF2
HF3
up to
FILL
6 boxes
UPDATES.
Code 420120326 REV.1.0
1
IN ITALY
2
29