Audio And Rdnet Connections - dBTechnologies DVA MINI G2 Manual Del Usuario

English

AUDIO AND RDNET CONNECTIONS

The figure above shows a general connection where a module 1 is above a module 2, showing
the audio and network connections. To this end, use the not supplied cables with XLR (audio)
and etherCON/RJ45 (network) connectors. For further information on the available types of
cables, refer also to the image in next page.
• For the audio connection, connect the cable originating from MIXER/LINE to the BALANCED
AUDIO INPUT (A) of module 1 of the line array. Re-link the signal between the first and the
second module. For this purpose, connect the output BALANCED AUDIO OUTPUT/LINK (B) of
module 1 to the BALANCED AUDIO INPUT (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules
of the line array are connected.
• For network connection, connect DATA IN connector (A) of module 1 to remote controller
(RDNet CONTROL 2 or RDNet CONTROL 8). Re-link the signal by connecting DATA OUT (B) of
module 1 to DATA IN (C) of module 2.
• Repeat the operation between the second and the third module and so on, until all modules
of the line array are connected.
DVA MINI G2
MODULO 1
MODULO 2
Code 420120326 REV.1.0
35