Normal Operating Sounds - TCL W5WR1 Manual Del Usuario

• Fan Mode – Fan Mode helps to circulate air in your home, but only works when the air
conditioner is vented.
• Fan Speed – Press the Fan Speed button to choose the fan speed options. You can choose
Hi, Med, Lo or auto speed in cool mode and choose Hi, Med, Lo in fan mode.
• Dry Mode – This function reduces the humidity of the air to make the room more
comfortable. Press the Mode button to set to Dry mode. An automatic function of
alternating cooling cycles and air fan is activated.
Timer Button – press the TIMER button on the panel or the Timer button on the remote to set
5.
the timer.
• Set Timer On: With the AC off, press the Timer button and then use the
buttons to set the desired temperature. Press the Timer button again and
and
timer button again to start the countdown.
• Set Timer Off: With the AC on, press the Timer button and then use the
buttons to set the length of time before the AC will turn off. Press the timer button again to
start the countdown.
Note: It can be set to automatically turn off or on in 0.5-24 hours. Each press of the buttons will
increase or decrease the timer. The Timer can be set in 0.5 hours increment below 10 hours and
1-hour increments for 10 hours or above.
The SET light will turn on while setting. To cancel the set function, press the TIMER button again.
Sleep Button – In Sleep mode, all of the display lights will turn off after a while, but the Sleep
6.
light stays on. In SLEEP mode, the air conditioner will automatically adjust the temperature
and fan speed to make the room more comfortable during the night. The set temperature
will automatically raise every 30-60 minutes, and at most change six times until the set
temperature is 81 or 82 degrees.
Filter Button – After the fan motor runs for 500 total hours, the Filter Check light will turn on
7.
to remind the user to clean the filter. After you clean the filter, you can turn off the light by
pressing the Filter button.

Normal Operating Sounds

You may hear a pinging noise, caused by the water hitting the condenser on rainy days, or when
the humidity is high. This design feature helps remove moisture and increase efficiency.
You may hear the thermostat click when the compressor cycles on and off. Water will collect in the
base pan on rainy days, or high humidity days. The water may overflow and drip from the unit on
the outside. The fan may run, even when the compressor is not on.
buttons to set the desired amount of time before the AC turns on. Press the
11
and
use the
and