Beper P206VEN150 Manual De Instrucciones página 11

3in1 Touch Screen Stand Fan Use instructions
Place the fan body (where the control panel is found) on the top of the upper column, and tighten the body
securing knob.
To install the fan at medium height, place and tighten the fan body on the top of the lower column; to assemble ta-
ble fan, insert the bottom of the fan body into the base, and tighten it with the metal washer and the locking lever.
To assemble grills and blade, remove and discard the plastic sleeve on the motor shaft. Place the back grill
against the front of the motor housing through the motor shaft. Ensure that the handle at the back of grill is facing
up and that all guiding pegs on the motor housing are lined up with cutouts on the back grill.
Secure the back grill into place with the dedicated nut, fasten it firmly onto the motor housing by turning it
clockwise.
Install the fan blade onto the motor shaft with the cutouts fitted. Place blade cap on the motor shaft after blade;
fasten into place by turning the blade cap counter-clockwise.
Attach the front grill to back grill, fastening it with the clamping ring by using a screwdriver and tighten to secure
it. Check the correct rotation of the blade.
Operation from control panel
Caution: ensure the product is fully assembled before plugging it into a power socket.
Place the fan on a flat, level and stable surface.
Plug into power socket, the appliance will enter standby mode.
The appliance can be operated through the control panel or with the supplied remote control.
Press ON/OFF button to turn the fan on: the fan starts running at the default middle speed (F2). Press again to
turn the fan off.
Press SPEED button to select the desired fan speed: display will show F1 for low speed, F2 for middle speed
and F3 for high speed.
Press SWING button to active the oscillation for widespread air distribution; press this button once more to stop
the oscillation.
To activate timer, press SWING button on control panel for 3 seconds until the timer indicator on the display
screen starts flashing; at this point, press SWING button again to set the automatic shutting off of the fan (timer
can be set in intervals of 1 hour to a maximum of 18 hours).
The selected timer setting will flash 3 times on the display and then it will turn back to show the selected fan
speed.
After the timer runs out, the fan will automatically shut off.
Unplug the fan when not in use.
Operation from remote control
The remote control includes one CR2025 battery. Battery comes pre-installed.
Pull the plastic insulation film out from the backside of the remote control before first use to activate battery.
The remote control functions are the same as the control panel on unit: follow instructions above to operate the
fan remotely.
To activate timer from remote control, press TIMER button until the desired time for the shutting off of the fan is
shown on the display; in this case also, the selected time will flash 3 times on the display, which then will turn
back to show the selected fan speed.
Note: the remote control must be pointed towards the receiver on the fan in order to work.
Please take out the battery when not in use for a long time.
Warning: keep new and used batteries away from children.
The remote control supplied with this product contains a button cell battery. Leaking or damaged batteries can
cause burns on contact with skin. The battery could potentially be a choking hazard for children. If the button
cell battery is swallowed it can cause severe internal burns in just 2 hours and can lead to death. If you think
the battery may have been swallowed or placed inside any part of the body seek immediate medical attention.
Warning: do not dispose of batteries in fire. Batteries may explode or leak.
11
EN