Features; Package Contents; Mounting Bracket Installation; Wiring - LEGRAND C2G30013 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

HDMI® HDBaseT + 3.5mm, USB-A to B, and RS232 over Cat Extender
Box Transmitter to Box Receiver - 4K 60Hz

Features

HDMI 1.4 with 4K@60Hz (chroma sub-sampling 4:2:0 8-bit only) and HDCP2.2 compliant
Using a Cat 6a/7 cable, transmit 4K@60Hz (YUV 4:2:0 color sub-sampling) signal up to 40m/130ft
and 1080P@60Hz signal up to 70m/230ft
Using a Cat 5e/6 cable, transmit 4K@60Hz (YUV 4:2:0 color sub-sampling) signal up to 35m/115ft
and 1080P@60Hz signal up to 60m/200ft
One-way POH, only one power adapter is needed to connect to TX to power both TX and RX
USB 2.0 pass-through, one USB Host built in TX and four USB Devices built in RX
High-speed USB 2.0 pass-through over HDBaseT up to 70m/230ft
One-way analog stereo audio, CEC pass-through and bi-directional RS232 pass-through over HDBaseT

Mounting Bracket Installation

Note: Before installation, please ensure the unit is disconnected from the power source.
1. Attach the installation bracket to the enclosure using the screws provided in the package
separately.
2. The bracket is attached to the enclosure as shown.
3. Repeat steps from 1 to 2 for the other side of the unit.
4. Mount and secure the transmitter and receiver to a surface or a suitable location respectively
with mounting screws.

Wiring

Warnings:
Before wiring, disconnect the power from all devices.
During wiring, connect and disconnect the cables gently.
Steps for device wiring:
1. Connect an HDMI source (such as PC, Blu-ray player, Apple TV, 4K media player, etc) to the HDMI IN of the transmitter using an HDMI cable.
2. Connect a Cat 5e/6/6a/7 cable between the HDBT OUT of the Transmitter to the HDBT IN Input of the Receiver.
3. Connect the HDMI display devices (TV, LED/LCD display, projector, etc.) to the HDMI OUT of the Receiver.
4. Connect for additional control options:
USB: Connect a USB Host device to USB HOST port of the Transmitter, and connect USB devices (such as keyboard, mouse and USB
camera) to USB DEVICE ports. The USB devices can be connected to the Host PC.
RS232: Connect a RS232 Master (or Slave) Device to RS232 port of transmitter, and connect a RS232 Slave (or Master) Device to RS232
port of receiver (More detail information, please refer to "RS232 Pass-Through" section.
5. Connect the included 12V power supply to the Transmitter. The PoH function carries power along the length of the cable one-way to power
the Receiver. No additional power supply is required for the receiver.
6. Power on all devices.
4

Package Contents

1 x Transmitter
1 x Receiver
1 x 12V Power Adapter
4 x Mounting Bracket (with screws)
2 x 3.5mm 3-Pin Phoenix Connector
1 x Manual
(us)
(us)

Publicidad

Tabla de contenido
loading

Tabla de contenido