Installation; Selection Of Installation Equipment - Klarstein FULL HOUSE 2.0 Manual De Instrucciones

EN
44

INSTALLATION

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing. For the purpose of
installation and use, a minimum of 5 cm space shall be preserved around the hole. Be
sure the thickness of the work surface is at least 30 mm. Please select heat-resistant and
insulated work surface material (Wood and similar fibrous or hygroscopic material shall
not be used as work surface material unless impregnated) to avoid the electrical shock
and larger deformation caused by the heat radiation from the hotplate. As shown below.
Note: The safety distance between the sides of the hob and the inner surfaces of the
worktop should be at least 5 mm.
A (mm) B (mm)
495 + 4 870 + 4
Under any circumstances, make sure the Induction cooker hob is well ventilated and
the air inlet and outlet are not blocked. Ensure the induction cooker hob is in good work
state.
C (mm) D (mm)
min. 50 min. 50
E (mm) F (mm)
min. 50 min. 50