V-TAC VT-5016–5 Manual De Instrucciones página 8

FIG 7
Step 7. Move the clips around the outside edge of the front guard outwards (see figure 7).
Step 8. Hang the front guard (1) over the top of the rear guard (5) (see figure 8).
FIG 10
FIG 8
Step 9. Bring the front guard down to meet the rear guard
and push the clips inwards until the front guard is fastened
to the rear guard (see figure 9).
Step 10. Finally fit the guard nut and screw (arrowed)
through the holes in the bottom edge of the guards and
tighten with a suitable pozidrive screwdriver (not supplied).
Note: this screw and nut must be fitted so that the guard
cannot be removed (see figure 10).
ENGLISH
FIG 9