Installation Instructions Electrical System For Towing Hitch; General Information - Westfalia 306 218 300 113 Instrucciones De Montaje

Installation Instructions
Electrical System for Towing Hitch
Westfalia Order No.:
Area of Application:

General Information:

Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
During trailer towing the rear fog light of the pulling vehicle is switched off by the control unit.
This must be retrofitted for towed vehicles without a rear fog lamp.
The failure of a turn signal, including on the trailer, is indicated by an increase in the flashing frequency.
As a result, no additional flashing check is required.
An electrical socket adapter may only be used during trailer towing, and must be removed after trailer
towing is completed!
The towed vehicle functions must be checked either with a towed vehicle or a testing instrument with
load resistance.
Withdraw the ignition key before hooking up the trailer.
Subject to modification!
12
306 218 300 113
Lancia Thesis'
13-pin
GB