Installation Instructions Electrical System For Towing Hitch; General Information - Westfalia 306 189 300 113 Instrucciones De Montaje

GB
Installation Instructions
Electrical System for Towing Hitch
Westfalia Order No.:
Fiat Order No.:
Area of Application:

General Information:

Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
During trailer towing the rear fog light of the pulling vehicle is switched off by the control unit.
This must be retrofitted for towed vehicles without rear fog lamps.
To avoid error messages from the lamp failure display, the towed vehicle should be equipped with two
fog lamps.
The failure of a turn signal, including on the trailer, is indicated by an increase in the flashing frequency.
As a result, no additional flashing check is required.
An electrical socket adapter may only be used during trailer towing, and must be removed after
trailer towing is completed!
The German version of these installation instructions shall be applicable in event of any legal
questions.
Subject to modification!
16
306 189 300 113
60 876 159
Alfa 156 Limousine
Sport Wagon
Crosswagon
Installation time approx.100 min.
13-pin