Update Firmware On Sub; Bootloader Mode; Automatic Update - Monitor Audio GOLD W12 El Manual Del Propietario

Update Firmware on Sub

Once the SubConnect app has loaded and
established connection with the sub woofer, either
by automatic detection or by you manually pressing
CONNECT, it will always check for a firmware
update. If it finds one, you will see the below image.

Bootloader Mode

To get the Gold W12 into bootloader mode, you
must first turn the sub woofer off by the mains
switch. When it has shut down, press and hold the
control dial while simultaneously turning the sub
woofer back on.
The Inner blue and cyan LEDs will illuminate with
the outer white LEDs flashing in a chase sequence
finishing at "Phase" (as per illustration below). This
is now in bootloader mode.
Now click on OK on the application. The "Status"
will show that it is disconnected. Click on
CONNECT and then when reconnected, the pop up
showing there is an update available will reappear.
Proceed to Automatic Update.

Automatic Update.

1. To carry out the update, click on OK. You will
then see another pop up showing the product,
version number and a brief summary of the
changes.
2. Click on Update and you will then see a
progress bar showing the status of the update.
3. When it is complete you will get confirmation
and the sub woofer will reboot (when you click
on OK). If there is a signal going into the sub
woofer, it will automatically start up. If there
is no signal, the sub woofer will need to be
woken up by applying a signal or by pressing
or turning the Control Dial.
monitoraudio.com 12