Assembling The Equipment - Tramontina TRO25 Manual De Uso Y Mantenimiento

ASSEMBLING THE EQUIPMENT

Detailed drawing, see pag. 04.
Parts, see pag. 05.
Step 1
Start assembly by locating the wheel package, [Fig. 01, Pag. 05]. Loosen the nuts (1), remove the screws
(2) and the washers (3) from the axles (4), [Fig. 02, Pag. 05].
Step 2
With the help of the nuts (1), the screws (2) and the washers (3) that you removed on "step 1", attach
the wheel package to the wheels support (5), [Fig. 03, Pag. 05]. Align the axle holes (4) with the holes
on the wheels support (5), insert the screws (2), the washers (3), and tighten them with the nuts (1),
[Fig. 04, Pag. 05]. See detail of assembled package, [Fig. 05, Pag. 05].
Step 3
Assemble the lower outlet (3). To do that, remove the screws (1) and the washer (2) that are attached
to the shell of shredder, [Fig. 06, Pag. 06]. After that, introduce the lower outlet (3) in the shell and use
the screws (1) and the washers (2) that you previously removed to attach it, [Fig. 07, Pag. 06]. See detail
of assembled lower outlet (3), [Fig. 08, Pag. 06].
Step 4
On the upper part of the shredder shell, you will find the screws (1) and the washers (2) to attach the
feed chute. Remove these to assemble the chute, [Fig. 09, Pag. 06]. Locate the axis (3) of the feed chute
on the back of the shredder shell. Remove one of the pins (4) and the axis (3) from the shell, [Fig. 10,
Pag. 06]. Prop the feed chute (5) on top of the shredder shell, [Fig. 11, Pag. 06].
Step 5
Use the axis (3) and the pin (4) to attach the feed chute (5). Make sure the feed chute (5) and the shell
couplings' holes coincide, insert the axis (3) and put the pin (4) back, [Fig. 12, Pag. 06]. After that, attach
the feed chute (5) with the screws (1) and the washers (2) that were removed on step 4, [Fig. 13, Pag. 06].
OPERATION
Set up the shredder in a dry place, protected from the weather, and over a smooth and flat surface.
Verify that the electric tension of the shredder is the same as the power outlet. The tension selector key
(127 V/220 V) is attached to the engine, on the rear of the shredder, [Fig. 14, Pag. 07].
To turn on your appliance, connect the cable to the switch and press the black button (I),
located on the side of the machine.
15
To turn it off, press the red button (0), [Fig. 15, Pag. 07].