MoistAir HD1407 Oak Manual Del Proprietário página 10

2. Open the pivoting lid and remove water
bottles and set aside. Grasp the fan
assembly front center and rear center. Lift
off and set aside on a clean flat surface.
The filter housings are now accessible.
3. Lift filter housing out of cabinet and place
where you may work on them comfortably.
With a soft, absorbent cloth remove any
remaining water or loose mineral deposits
not trapped in the filter from the humidifier
cabinet.
4. To open filter housing for easy access to
filters:
a. Deflect the two spring tabs on top of
filter housing. Lift top cover off of the
filter housing and set aside.
b. Remove the two filters and dispose of
properly. Clean internal parts of
humidifier per the "Care and
Maintenance" section (page 11) of your
operator's manual.
c. Install new filters in the filter housing
track with the glue beads of the wicking
pad to the inside of the filter housing.
d. Return the top cover of the filter housing
by installing cover over the fixed tabs on
the rear of the lower filter housing and
pivoting the cover down over the top of
the filters.
Snap the cover over the two spring tabs.
e. Replace the filter housing in the cabinet.
NOTE: There is a front and back
orientation. To position the filter
housings correctly:
• Be sure that the spring tabs of filter
housings are towards front of
cabinet.
• Align the lower portion of the filter
assembly over the six ribs located
at the bottom rear of the humidifier
cabinet.
f. Position fan assembly onto the
cabinet. Make sure the fan venturi
(lowest cylinder section below the fan)
is placed inside the filter housing.
g. Replace water bottles.
h. Close the pivoting lid.
i. The unit is ready for use or to be
stored away for next season.
10